- Side pieces are 1/4" thick Cold Roll Steel that is CNC milled
- Hitch plates (top corners for the chains) are 3/16" Hot Roll Steel that is cut on a waterjet
- Lower pivot piece is 1/8"-wall Mild Steel Tube
- Center Section (where it would normally say "Jeep") is 18 Gauge Cold Roll Steel
- Everything else is laser cut 16 gauge Cold Roll Steel.
The actual pivot brackets are all CNC milled / turned and include a back plate for if / when your bolts snap off.
The stock OEM Jeep latch / latch mechanisms fit these tailgates.
**Note: these are aftermarket tailgate panels and not OEM / NOS units. They do not include the Jeep logo.
- Fits 1963-1972 J-Series Pickups including Gladiator
- Models All with Fleetside Bed
- Will NOT fit Stepside Models
- Brand New!
- Made in the USA!
There are currently no reviews for this product. Pease write a review by clicking the button below.